Matt
Administrator
Went round to Si's today to help fit his new GSI interior.
The seats are in very good condition.
Removing the front seats was nice and straight forward, but we had a real mare with the last bolt holding the centre seatbelt and buckle in place. The T50 bit rounded off the bolt, and we spent about 50 minutes trying to remove it using various different bits and a large hammer. We ended up managing to get a set of maul grips to grasp is just enough and both of us had to pull on it to get it to turn.
While the interior was out, we gave the inside a good clean and hoover.
The new one went in without any major problems (apart from the drivers seat having two loose bolts on the bracket holding the back of the seat to the base causing a wobble on the rear of the seat).
The seats are in very good condition.
Removing the front seats was nice and straight forward, but we had a real mare with the last bolt holding the centre seatbelt and buckle in place. The T50 bit rounded off the bolt, and we spent about 50 minutes trying to remove it using various different bits and a large hammer. We ended up managing to get a set of maul grips to grasp is just enough and both of us had to pull on it to get it to turn.
While the interior was out, we gave the inside a good clean and hoover.
The new one went in without any major problems (apart from the drivers seat having two loose bolts on the bracket holding the back of the seat to the base causing a wobble on the rear of the seat).