you will need a logo made ether (vauxhall,astra SRI,coupe,irmscher) but the will need to be pin line type so there is no middle to them you local vehicle graphics shop should do them made to suit..also dark tint and chrome tint (reflective)
1,get some dark smoke window tint then on the screen measure down 9" and mark with masking tape while its dry,then use some soppy water and give it a clean window squiggy is good, place your tint on the screen with the straight edge facing down so you get a nice clean line,make sure the tint is in line with the masking tape then with a sharp break off blade knife look thru the tint so you can see the black edge on your window screen and cut the tint about 4-6mm in to the black bit so you don't have any sunlight showing thru when its on remember to cut round the mirror bit.
now clean the inside the same and spray soapy water on the area to be tinted on the outside the tint has a clear backing make sure this is facing out remove the clear liner and spray the tint with the soapy water pick the tint up making sure not to touch it on any thing and place it in the screen just a quick blow will help if it stars to peel off while you fitting it now realign it with you masking tape and squiggy all the water from behind the tint and leave to dry ova night
2,now have your logo fitted to the screen
3,now that your logo is fitted see how the pinstripe writing is from the inside take you sharp knife and cut round the logo on the inside
remove the tint on the inside of your logo so the center is transparent
4 ,now you will need the chrome tint and cut it the same as above but make it 1/2" longer so put your masking tape 9,1/2" down from the rubber
wet the inside of the window and remove the clear backing and wet the tint with soapy water and fit over the top of your dark tint
make sure the chrome tint sits to your masking tape marks have a check and make sure its all square and then squiggy out the water job done have a good look a your new sun strip
here was my old one that had to be removed for mot
1,get some dark smoke window tint then on the screen measure down 9" and mark with masking tape while its dry,then use some soppy water and give it a clean window squiggy is good, place your tint on the screen with the straight edge facing down so you get a nice clean line,make sure the tint is in line with the masking tape then with a sharp break off blade knife look thru the tint so you can see the black edge on your window screen and cut the tint about 4-6mm in to the black bit so you don't have any sunlight showing thru when its on remember to cut round the mirror bit.
now clean the inside the same and spray soapy water on the area to be tinted on the outside the tint has a clear backing make sure this is facing out remove the clear liner and spray the tint with the soapy water pick the tint up making sure not to touch it on any thing and place it in the screen just a quick blow will help if it stars to peel off while you fitting it now realign it with you masking tape and squiggy all the water from behind the tint and leave to dry ova night
2,now have your logo fitted to the screen
3,now that your logo is fitted see how the pinstripe writing is from the inside take you sharp knife and cut round the logo on the inside
remove the tint on the inside of your logo so the center is transparent
4 ,now you will need the chrome tint and cut it the same as above but make it 1/2" longer so put your masking tape 9,1/2" down from the rubber
wet the inside of the window and remove the clear backing and wet the tint with soapy water and fit over the top of your dark tint
make sure the chrome tint sits to your masking tape marks have a check and make sure its all square and then squiggy out the water job done have a good look a your new sun strip
here was my old one that had to be removed for mot
