lds1973 is it the same as the astra HOW TO? I have a 2001 sri150 or can I access the last pipe of the three pipe mod (the one infront of the splash guard, under the drivers lamp) from just removing the wheel and splash guard??? Cheers Lee
evocarlos this should help i googled (vectra front bumper removal) Remove the front grill by unscrewing the three securing bolts that hold it in place) Jack the front of the car up so you can get underneath. (remember to use axle stands to secure car) The front bumper has two top centre bolts underneath where the grill was. At the front underside of the bumper there are several plastic push-in plugs - remove them. Also disconnect the wiring for the front fogs (if fitted). Remove the two screws that secure the wheel arch lining to the bumper - these are located at the front lower outer edge on either side of the car. Undo the torx screw that secures the wheel arch lining on either side of the bumper, Behind the wheel arch liner there are two securing bolts. You will have to reach nearly right to the top inside of the bumper to locate these. These help secure the side of the bumper in place. (I see you have already mentioned these, as this is the bracket you superglued back onto the bumper) Once you have undone all of the above, gently pull each side of the bumper forward as there are locating lugs on either side.