so a mate of a mate give me a spoiler for his car puke.. mg tf and said could you paint it ....
it was one of these cheap fiber glass copies very poorly made might i add
so here's what i did.. (I used a compressor and suction feed spray gun)
- as you can see this lump is not meant to be here had to burr it out as i said cheap copy.
2.then i went over with high-build primer because the front and back edge were full of holes.
3.the holes that were left i filled with knifing putty then the hole thing was wet and dryed with 600grit.
- next up was the color had it mixed at the local shop i did 2 layers wet and dry-ed between the 1st and 2nd layer .
5.then i put 3 coats of lacqer on, 2 thick coats and one with thinners in to make it shine more after the lacqer was dry it was flatted down with 2000 grit removing any hi spots and imperfections.
6.then my bestist friend T-cut give it a good polish bringing back the shine you can see the difference in the pic of wet and dryed and polished.
7.after it was all T-cutted i put it on the wall out side to see how it looked in natural light and it did look good i must admit.
8.final prep was T-cut all over and polish with maguires tec wax to protect and bring out the glossy finish... done..
