evocarlos kind of a tricky question and i would normally be answering it lol but i cant seam to fine the info with my google foo anyone shed any light ? @[deleted] ive found a full single mass conversion kit but its for the leh
vocky I think the flywheel is 6 bolt on the z20leh. The leh has a bigger diameter clutch than the z22yh / z20ler, think ours are 228mm and the leh is 240mm, so would still probably fit
vocky I just realised why TTV screw up the z22se M32 flywheel, they probably use the z20leh spacing, so one bolt hole will need machining a couple of mm as it's offset on the leh
evocarlos took a sketch of a z20let flywheel today and have been informed the dual mass of the vxr has the same hole pattern altho i cant tell from the pic if theres is a bolt out of place lol
dewismotorsport If it helps a C20LET flywheel is the same as the Z22SE so may be easier to check if the C20LET is the same as the Z20LEH, as it's probably a more searched out question
evocarlos dewismotorsport said: If it helps a C20LET flywheel is the same as the Z22SE so may be easier to check if the C20LET is the same as the Z20LEH, as it's probably a more searched out question so the c20let has symmetrical hole spacing ? but there not dual mass for the conversion i need the extra width of the single mass conversion flywheel to meet the splines on the m32 had another closer look at the scribble of the z20let one and one hole is just off by about 2mm like @[deleted] said
dewismotorsport Holes aren't symetrical, same as z22se. Other option is to space the release bearing from behind. EDIT: just realised you need the clutch to sit out further.
evocarlos the z22se one has a symmetrical pattern i ment 🙂 tryed the z20let doodle under the z22se on you can see the one hole difference and the 2 doodles side by side
evocarlos vocky said: I just realised why TTV screw up the z22se M32 flywheel, they probably use the z20leh spacing, so one bolt hole will need machining a couple of mm as it's offset on the leh or ttv are just sending out astra vxr flywheels to suit lol new fly wheel is in the post and ive got to ring back for the clutch once i confirm the flywheel is suited
evocarlos think the new flywheel is going back its 14.5kg's that makes it 1.5 kg's heavier than the dual mass :S
evocarlos HarleyPete said: That's not good really is it. fitment and height is good and the starter ring matches but i can't deal with it being 10kg over weight
dewismotorsport Surely they could of took some of the meat out the sides like they do the pot type flywheels for the C20LET and Z22SE
KevinH evocarlos said: fitment and height is good and the starter ring matches but i can't deal with it being 10kg over weight You'll have to go on a diet to compensate for the extra weight ! :LOL:
