dewismotorsport's Astra coupe

evocarlos

chill said:
You got pic
I can't remember what I did but I used logic
Lol

yes logic was what i did
pretty sure i put the gaps in the parts with body and not the inlet or outlet holes

@[deleted]
also make sure you dont have any dinks in the laminover ends or you will have water in you inlet like i did
it was from pulling the cores out with pipe grips

Dave_Gilbert

I understand everyrhing everyone has said except
laminover hahaha(it all looks nice though)

5M1THY

What is the best way to take the laminovas out without causing damage presumably there in there reasonably well if there fitted with o rings

evocarlos

5M1THY said:
What is the best way to take the laminovas out without causing damage presumably there in there reasonably well if there fitted with o rings

yeah they stick in small jubilee clip on the end then a pair of plyers on the clip best to use the stainless cheapo ones they're a bit softer and flex the genuine jubblies are rock hard and dig in they only need a nip twist and pull 🙂

Dave_Gilbert

they only need a nip twist and pull........
sounds kinky hahahaha

5M1THY

Nice one ill give it a go on Saturday and post the final job 🙂

evocarlos

5M1THY said:
Nice one ill give it a go on Saturday and post the final job 🙂

you could put some tape on there to protect the end also ?

5M1THY

evocarlos said:
you could put some tape on there to protect the end also ?

yeah I was definitely going to do that.. bit of tape cheap jubilee clip and twist and pull 🙂

evocarlos

just go carefull there not cheap to replace 🙂

5M1THY

Will do cheers mate 🙂

milo

@[deleted]. U can swap mine around then lol

dewismotorsport

I just used some wide mouth pliers and wrapped a rag round them came out fairly easy

5M1THY

What size are the o rings and how many as I'll grab some before I do it

dewismotorsport

5M1THY said:
What size are the o rings and how many as I'll grab some before I do it

29.74x3.53

evocarlos

theres a technical sized name for them to but i cant remember lol
z16?

Dave_Gilbert

Iv just got 1 of these n match it best I can(very really needed it for owt important)

evocarlos

Dave Gilbert said:
Iv just got 1 of these n match it best I can(very really needed it for owt important)[ATTACH]58631[/ATTACH]

thats what i have but metric and imperial and the ones the same as the laminova ones came out the imperial box the metric ones were not thick enough to match

Dave_Gilbert

I think mines all metric.

I bet imperial 1s arnt as easy to get hold of

5M1THY

Cheers guys I'm pretty sure if I took one to my pal at the motor shop he will have some or my dad might if not ill just buy the ones from zzp

5M1THY

It's only £9.99 for a set of 400 imperial o rings

« Previous Page Next Page »