Is this the correct 2.4L intake manifold?

markel

hello all.

I recently purchased an opel astra g z22se and I would like to put the 2.4L intake manifold.

The problem is that I bought one in the U.S. but it is not like I've seen here. In the store of purchase admission, they said it was for the 2.4L engine but it is like that of the 2.2L engine.

I've looked at some American pages and looks like using the chevrolet malibu 2.4L of 2010 but not ion or cobalt.

The reference number that I've bought is # 12602735
but I think yours is # 12587878

You think that would serve me that I have?

Thanks and sorry for my bad English

A greeting

Matt

I've moved the thread into the specific 2.4 manifold section.

markel

sorry to put it where it was. thanks

Matt

No worries.

I think @[deleted] and @[deleted] will be best suited to answer, as they have seen and fitted a few of the 2.4 manifolds.

vocky

It is the later 2.4 inlet manifold, so should be better than the 2.2.

markel

So you think I should put it and there will be some improvement, or sell it and buy me another

Matt

markel said:
So you think I should put it and there will be some improvement, or sell it and buy me another

Yes fit it 🙂

markel

Then if it looks like there should be a profit also similar? I say this to know if it is worth and not to lose time by putting it.
thanks again

Matt

Have a look through some of the threads in this section. There is quite a lot of information and people did rolling roads after fitting the 2.4 manifold

markel

I have been looking the other topics and I and understand that mine is not correct. I order the right and already underway. Thank you very much for everything

markel

Hello. I finally decided to mount the collector and not as holding the ecu. sold some support to secure? thanks

vocky

courtenay used to sell the mounting kit, but I am unsure if they still do

markel

I've been looking and have nothing for the ecu. I have also looked on ebay but have not found anything