Dazzler The car has started to do the above. If you turn ignition off again and then try again it starts normally. Any ideas? I would like to sort this before it becomes a big problem and wont start at all. Tia
evocarlos is it opcom ? you dont need pass code to read error codes unless its different on the full can bus system
evocarlos yeah its opcom load up the software year>zaffy>engine>z22yh>error codes but i think with your car theres an option to check all dtc's at the start
Dazzler Silly question....... When do you plug in the op-com?? Ignition on/off, engine running etc....??? Ta muchly
Matt Dazzler said: Silly question....... When do you plug in the op-com?? Ignition on/off, engine running etc....??? Ta muchly You would normally plug the code reader in while the engine is off, and then turn the ignition on / start the car after.
Dazzler Well................. Main fault code is p1112 swirl flap stuck..........any fixes? The other 2 were wrong transponder key and steering column module.......im guessing it doesnt always see the key??? hence original fault . I have cleared these 2 but swirl flap is in red and latched solid so i guess its real and going to cost a few bob.
Dazzler swirl flap bar can be moved by hand so i assume the flaps are moving and there is a slight resistance which i take to be the actuator. any ideas?
