Fairly urgent request - injector seal size

Lugy

Hi folks, got a urgent request that hopefully someone can help with!

Need to know the size of o'ring used between fuel rail and injector (Z22SE if it's different from the other one!), even the diameter of where the o'ring fits would be massively useful too I think!

Would be massively grateful if anyone can help 🙂

Lugy

No need to worry, managed to get the car recovered to my work, checked out the seals and discovered they're non standard! Luckily I have a scrap head that still has injectors/fuel rail in that I can pillage, it's just 40 miles away! Lol.

evocarlos

they will be viton

OD 14mm ,ID 8mm and about 3mm thick

use bum lube on refitting to stop them getting cut

Matt

evocarlos said:
use bum lube on refitting to stop them getting cut

Carl just drives around with a pot of that in his car anyway :whistle:

evocarlos

Matt said:
Carl just drives around with a pot of that in his car anyway :whistle:

its run out but i did have a tub in the car lol 🙂

Matt

evocarlos said:
its run out but i did have a tub in the car lol 🙂

That's a lot of dogging!

evocarlos

Matt said:
That's a lot of dogging!

not as much as you were thinking it was more lol

Sjdickso

That's a fair size tub Carl lol

Sidicer

Revining an older one to not create something simmilar. Maybe anyone has info what the bottom o-rings are sized? Inner/Outer diameters and Girth ?Also, am I stupid or the upper ones cannot be 14mm when Inner diameter is 8mm and width of the ring is about 3mm? 8+3 != 14