Speedo Not Working

corsaZ22se

after fitting the vectra b Z22se into a corsa c im having problems with the ecu not talking to the bcu, no oil preasure light and speedo gives wild readings. i know the corsa uses canbus and the vectra only used it for abs and traction control, the rest of the dash works ok so im hoping its just a wiring issue at the ecu? does anybody have a wiring schematic for the astra g z22se showing ecu pin termination and wire destinations?

vocky

oil pressure switch is just above the starter motor, z22se cars use an abs wheel sensor for the speed signal

vx220 z22se ecu wiring part 1 = http://www.speedsterclub.nl/bibliotheek/technische documentatie/tis/Wiring Diagrams/Engine System/Multec/Circuit Diagram/Engine Z22SE - 1.pdf

ecu wiring part 2 = http://www.speedsterclub.nl/bibliotheek/technische documentatie/tis/Wiring Diagrams/Engine System/Multec/Circuit Diagram/Engine Z22SE - 2.pdf

corsaZ22se

they also need a trigger from the ecu to abs for wheel speed, this is also the trigger for eps on corsa c and the astra g. the green wire on the vectras loom was for this and to the rev counter so its not quite the same signal which could be where im getting interferance from? oil preasure switch is ok its not conected to the ecu on a vectra b, straight to the dash. thanks for the schematics but they dont show the part i need. realy do need an astra g schematics like this if anybody has one?