poundy spent most of the day doing the below, its one of those new electronic gauges and im quite pleased with the result.been playing with loads of ideas but settled on the below. only thing is i cant get it to work lol, so im not sure now that it was a good idea!! can someone tell me, just in case i got it wrong, which pipe to connect the vacuum tube to, if ive dont it right then ive brough a load of crap and will get a standard one. the fact that ive done all the hard work already means i would just have to run a tube to the tee peice cheers fixing it though was a real bitch, but in the end it was worth it.i had to drill up in between the light control unit then mount a plate underneath so i had somewhere to bolt it to.it does squash to dash a little but its not too bad, and because its soft you only have to make a little hole. cables were run behind the dash when it was all back together it looks like this looks ok but it will be even better if i can get it to work!!
poundy JohnnyN said: Mine is on a T-piece on the take off on the top of the inlet manifold Paul. can you show me in a pic?? im sure that where i took mine from, but just to be sure. its prob the gauge or the sender unit. its a new type on the market so the tubing doesnt go back to the gauge itself.
Matt poundy said: JohnnyN said: Mine is on a T-piece on the take off on the top of the inlet manifold Paul. can you show me in a pic?? im sure that where i took mine from, but just to be sure. its prob the gauge or the sender unit. its a new type on the market so the tubing doesnt go back to the gauge itself. Mine is an electric one Paul, and the tubing from the fuel pressure regulator goes to the electric sender which I located inside the car.
poundy poundy said: JohnnyN said: thats about whwre i put mine.there must be something wrong with mine then ive ditched this idea.ordered a new one today that has supercharger on it. live and learn!
