Vectra B Sri150 Trip computer wiring

Tubbe

I would like to know if anyone could help me with this. So I have a Sri150 with TID and I would like to change it to MID. The car doesn't have all the wires which is needed to get the trip computer work. I have done this mod to Sri140 which was easy because ECU had only one connector where the wires were. Now because my car has Z22SE engine the ECU doesn't have the fuel signal wire which is vital to get the trip computer work. So I need help from you guys how could I open/mod the ECU connector so that I'm able to add this fuel signal wire to the connector. When this problem is sorted out I can start fitting the trip computer display and MID stalk to the car.

vocky

it should be just a case of adding the missing wiring, perhaps it might be easier to get another loom from the breakers and get the wires from that

Tubbe

I've been thinking of that too but first I'm trying to add the missing wire. If it's too difficult then I'm going to buy the loom from the breakers.