SpaceWalker Hello Gents, Please help me to find the best offer for the parts above. I've tried from http://autopartspeople.com/, but those guys asked from 330$ dollars delivery, and a brand new 2.4 Manifold and 2.0 TB cost me 300$ if i order them from there. Could you help me please from where i can order them with good price? Also i am looking for CAMS, i've tried with COMP CAMS, but they do not ship to Europe and also with Piper. Could you help here as well please? Much appreciate your help guys. Regards!
vocky drop Karo at www.allecotec.com an email, tell him vocky sent you, he should be able to supply all you require 🙂
vocky he can still supply them 🙂 I've bought some GM parts from him which are not listed on his website
SpaceWalker Just spoke to the guy he shall help me with all 3 items which i am looking for. Many thanks vocky for the help. BTW - i've ordered the EGR Cheater as well 🙂
Matt SpaceWalker said: Just spoke to the guy he shall help me with all 3 items which i am looking for. Many thanks vocky for the help. BTW - i've ordered the EGR Cheater as well 🙂 When did you order the cheater?
SpaceWalker Guys, also for the Balanced Shaft deletion - should i order a kit or i can use the Balance Cams for the spining?
vocky the blank shafts are much easier to fit, but the delete is perhaps better I run the delete set up in my engine, oh and every other engine I've built :lol:
SpaceWalker I mean i shall remove the balance shaft and shall go to a turner to produce bushes which shall stop the oil lines. My question is can i use the balance shaft chain wheels to spin the balance chain? Can you also give some photos how you are fitting the deletion kit? And is there any short chain to spin only the water pump?
vocky all you need to do is cut off the ends from the balancer shafts and get the end machined smooth, then refit it to the bearing and refit the sprocket then get some bushes made for the rear bearings, job done 🙂
SpaceWalker THank you very much for the info. By any chance do you have the dimension of the bushes and from what material they need to be produced (aluminum)? Much appreciated!
vocky I cannot remember the size for the bushes, I just force the rear bearings 7.5mm further into the block instead. aluminium would be fine for the bushes.