Mounting the engine on a stand?

I've just bought a Sealey engine stand which has 4 adjustable hollow tubes, about an inch in diameter like this...

The question is, how do you use those to mount it to a z22se? I can't see any obvious mountings...

you bolt them to the where the gearbox bellhousing bolts go 🙂

Hmm, can't see how you'd do that with just a hollow tube...

long bolts lol

p.s any luck on that hardtop 😉

Yeah as above you put long bolts through the tubes and then bolt to the block lol

Muncher83 said:
Hmm, can't see how you'd do that with just a hollow tube...

So:

Excellent, I don't suppose you could tell me the bolt sizes and lengths could you please?

Muncher83 said:
Excellent, I don't suppose you could tell me the bolt sizes and lengths could you please?

I don't remember that now... dunno.. tomorrow I will measure them :wink:

The upper two are M12 / 120mm, the lower one is M8 / 80mm, but the length depends on length of your “tubes”…

Thanks a lot, it looks like my stand is the same as yours 🙂